WNR1000-2VCNAS Firmware Version 1.0.0.12

Enhancements and Bug Fixes

  1. Fixed IPsec, PPTP, and L2TP Passthrough
  2. Corrected issue such that log entries are not flushed after sending log
  3. Fixed UI bugs in router status page
  4. Corrected issues with RIP
  5. Fixed Ethernet driver lock up issue if port is flooded during power up
  6. Fixed issue where setup wizard is able to detect as DHCP connection but can't establish internet connection by selecting APPLY or TEST button.
  7. Fixed issue with not able to reset to factory default sometimes.
  8. Disabled traffic meter per request from Comcast
  9. Fixed SNMP to allow access from WAN side. 

Installation Instructions

  1. Download the file to a convenient place such as your desktop.

    Note: Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.

  2. Open a Web browser.
  3. Access the router (http://192.168.1.1 or the Default Gateway address if the router's default IP was changed).
  4. Log in the router (User Name = admin and Password = password, unless you changed it).
  5. Write down all settings that you entered when previously configuring. This includes information such as ISP configuration and wireless security settings.
  6. Under Maintenance, click Router Upgrade.
  7. Click Browse and locate the firmware upgrade file.
  8. Click Upload.
  9. Wait for the router to reboot.
  10. Under Maintenance, click Settings Backup, then click Erase. (Or press the reset button on the back for 10 seconds.)
  11. Wait one minute for the router to reboot.
  12. Manually enter the configuration information you wrote down in Step 5.

 

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.

 

Document Type

Downloads > Driver/Software/Firmware
Published 06/09/2011 08:49 AM   |   Updated 11/02/2011 07:53 PM

 

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.