WNDR3400 Firmware Version 1.0.0.50

Note: Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only. You must reset the router to factory defaults after the upgrade.

New Features and Enhancements

  1. IPv6 Support.
  2. Port Forwarding enhancement. 
  3. Auto Internet Disconnection/Connection (24 hour Internet disconnection for Germany).
  4. IGMP Proxying.
  5. L2TP
  6. IE9/FireFox4/Chrome/Safari support
  7. Support 3TB HDD for ReadySHARE

Known issues & bugs

  1. Traffic meter – Traffic volume control is not accurate due to sampling rate. It may exceed the limit.
    Workaround: Set a proper number in “Mbytes before the monthly limit is reached” in the traffic control.     

To Upgrade

Note: Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only. 

You must reset the router to factory defaults after the upgrade.

  1. Write down all the settings which you changed from the default values, since you may need to reenter them manually.
  2. Download using the button below to a convenient place such as your desktop.
  3. Log in to the router using a Web browser. The URL is http://192.168.1.1 ( if you did not change the router’s IP address ).
  4. Click Maintenance > Router Upgrade
  5. Click Browse and find the file you just downloaded.
  6. Click Upload. Do not interrupt the upgrade while the router does this step. The router reboots when the upgrade is done.
  7. After the router boots up, log in the router again.
    You MUST Reset the router to default settings after upgrading the firmware
  8. Click Maintenance > Backup Settings
  9. Click Erase. The router reboots when the Erase operation is done.
  10. If you would like to check that the upgrade was successful, log in to the router again athttp://192.168.1.1, and check the firmware version.
  11. Re-configure the router with the settings you saved in step 1. Optionally, You can use the Smart Wizard configuration assistant on the CD to reconfigure the router.

 

Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate.

 

Document Type:

Downloads > Driver/Software/Firmware
Published 01/04/2012 05:49 AM   |   Updated 01/04/2012 05:49 AM

 

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.