WNDAP360 Firmware Version 2.1.11
Fixed issues :
- Added GUI, CLI and SNMP support to configure “Rest of World” country.
- Increased the EAPOL timeouts in hostpad from 1s to 2s. Increased number of timeouts from 3s to 10s.
- Fixed the slow GUI response issue when wrong DNS server address is configured in the AP.
- Added support for IGMP snooping.
- Added CLI command to switch between external and internal antennas.
- Fixed beacon synchronization issues in HT40 mode.
- Fixed the issue that client connected to each band, but it only shows 2.4GHz band.
- Changed the code to support CE Adaptivity.
Known Issues & Limitations
- A configuration saved from previous firmware version cannot be loaded on an Access Point running newer version. A new backup configuration must be taken after firmware upgrade if is wished to store for later use.
NOTES :
- The default IP address of the AP is 192.168.0.100
- In the following scenarios AP is expected to reboot automatically for the configuration to take affect:
- Change Country/Region
- After Firmware upgrade
- After Restore Configuration Settings
- Reset factory defaults
In all the other conditions AP is not supposed to reboot automatically.
- With Rogue AP and more than 2 VAPs (security profiles) enabled, the beacon interval of the AP will be automatically updated for better performance of the Rogue AP algorithm. We recommend not to reconfigure the beacon interval below the suggested value. Anything above the suggested value is fine.
- 1 or 2 VAPs enabled, beacon interval is 100ms
- 3 VAPs enabled, beacon interval is 41ms x 3 = 123ms
- 4 VAPs enabled, beacon interval is 41ms x 4 = 164ms
- 5 VAPs enabled, beacon interval is 41ms x 5 = 205ms
- 6 VAPs enabled, beacon interval is 41ms x 6 = 246ms
- 7 VAPs enabled, beacon interval is 41ms x 7 = 287ms
- 8 VAPs enabled, beacon interval is 41ms x 8 = 328ms
To Install
- Write down all the settings which you changed from the default values, since you may need to reenter them manually.
- Login to Web Administration interface of the Access Point -
By default, http://192.168.0.100 is the Administration URL to the Web GUI. Enter admin for the user name and password for the password.
- Click Maintenance > Upgrade > Firmware Upgrade.
- Click Browse and select the firmware image you just downloaded.
- Click Upload.
Do NOT interrupt or power off the computer until the upgrade process is completed. Wait for the AP to reboot.
This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.