WG102 Firmware Version 5.0.1

North America (N.A.) & World Wide (W.W.) releases

Modifications:

1. This version allows downgrade from WG102 to WGL102. This was not possible in the previous version 5.0.

Known Limitations

1. The access point needs to be rebooted after configuration changes.
2. Only tagged VLAN are supported.
3. Turn Access Control On checkbox gets cleared automatically after adding a trusted MAC Address to the Access Control List.

To Upgrade

Warning:

• Do NOT interrupt the upgrade process until it is done.
• Device will enter TFTP mode, if you press and hold the rear reset button for over 15 seconds. To exit the TFTP mode, please power cycle the devic

1. Choose the correct download for your country. Download the link below and save it to a convenient place such as your desktop. 
2. Log in the WG102 access point.
3. Search the Management section, and click the Upgrade Firmware.
4. Click Browse and select the firmware image (.img) file from the folder where you downloaded the file.
5. Click Upgrade to start upgrading. This takes several minutes. 
   Do NOT interrupt the upgrade process until it is done.
6. The access point will automatically reboot after the firmware upgrade process is complete.

MIB File for SNMP Monitoring (optional download):

• MIB for North America Version
• MIB for World wide Version

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.