SRXN3205 Firmware Version 3.0.7-24

Published on 03/18/2011

New Features:

• Suport IP multicast passthru and IGMP snooping to enable the media streaming and gaming application pass thru between WAN and LAN connects.
• Add SNMP OID for CPU utilization.
• Add watchdog timer and system health monitor to collect more counters and system information.
• Allow to configure custom ports between 0 to 1023.
• Support iPhone VPN client connection.
• Add checkbox in LAN setup page to allow enable and disable the ARP broadcast.
• Allow to cusomize the client ID in DHCP client configuration.
• Support IP address group in WAN user so that it can be used in the Firewall inbound rules.
• Allow up to 256 characters in configuring the text banner for SSL VPN portal.
• Support per IP address base bandwidth limit in traffic meter setup.
• Increase WAN's secondary IP address maximum to 24.

Bug Fixes:

• The guest user is no longer able to update or delete some fields in WAN setup page.
• Resolved the issue of WAN port getting reset when using 2 DSL lines from the same ISP with load balanacing mode.
• DynDNS record will be updated with the new IP address when WAN port gets assigned new IP address.
• It is now allowed to map a higher port number to a lower one in Firewall rules.
• Admin is able to save the DHCP client vendor identifier or vendor class identifier.
• Checking is added to prevent user to create duplicate protocol binding policies.
• 2 PCs in DMZ network is able to access each other when they are using public IP addresses.
• Resolved the issue that all WAN ports get reset when reconfiguring a WAN port.
• WAN load balancing function will apply to the WAN port that is just back on line.
• Resolved the issue that LAN port MAC address was saved in the backup file. 

Known Issue(s) and Limitations:

• SSL full tunnel is not supported for MAC OS 10.6 please use split tunnel as alternative.    
• Windows 7 64-bit SSL VPN is not supported on Firefox.
• Defaults SSL global deny policy should be grayed out.
• Protocol binding should be configurable only in load balancing mode, but can be configured in dedicated & auto roll over modes also.
• LAN and DMZ host IP are accepted in DMZ-WAN and LAN-WAN respectively for inbound services.
• Able to configure Dyndns for ADSL and Ethernet irrespective of WAN Mode type.     
• PPTP idle time out is not working when IGMP proxy enabled.
• Bandwidth profile is not working over vpn tunnel. 

Installation Instructions:

• Download the link below and save it to a convenient place such as your desktop.
  Note: Reboot the firewall before begining the update process.
  
• Select Administration > Settings Backup and Firmware Upgrade from the main/submenu.
• In the Router Upgrade section, click Browse.
• Locate the downloaded file and click Upload.
  This will start the software upgrade to your VPN firewall.  This may take some time. Do not interrupt the upgrade process.
  At the conclusion of the upgrade, your firewall will reboot.

Document Type:

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.