MBR624GU Firmware Version 6.01.30.64 (All regions except North America)

Released on: 04/08/2011

New Features and Bug Fixes:

  1. Added following modem support:
    a. Sierra Wireless 312
    b. Huawei E1765
    c. Huawei K4505
    d. ZTE MF112
    e. ZTE MF180
    f. ZTE MF626
    g. ZTE MF627
    h. ZTE MF636DB
    i. ZTE MF637
    j. ZTE MF652
    k. ZTE K3570Z 
  2. Fixed issue where address reservation is lost when LAN IP address is changed. 
  3. Fixed auto reconnection issue. 
  4. Fixed security hole that allow access to UI without authenticating. 

Known Issues :

  1. In some rare occasions, router cannot recover from loss of communications with modem.
    Workaround – eject and re-insert modem.
  2. Cannot create a static route using subnet address as destination.
  3. Edit existing wireless access list creates a new record.
  4. Cannot set trusted IP address to access blocked sites.
  5. Some devices connected to the router are not displayed in the attached device list.
  6. After manually disconnected modem, when user tries to access internet, router does not warn user connection has been manually disconnected.
  7. Static route is deleted without warning after edit with duplicate information.

Upgrade Instructions:

  1. Download the file to a convenient place such as your desktop.

    Note: Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.

  2. Open a Web browser.
  3. Access the router (http://192.168.0.1 or the Default Gateway address if the router's default IP was changed).
  4. Log in the router (User Name = admin and Password = password, unless you changed it).
  5. Write down all settings that you entered when previously configuring. (Usually this includes information such as ISP configuration and wireless security settings.)
  6. Under Maintenance, click Router Upgrade.
  7. Click Browse and locate the firmware upgrade file.
  8. Click Upload.
  9. Wait for the router to reboot.
  10. Under Maintenance, click Settings Backup, then click Erase. (Or press the reset button on the back for 10 seconds.)
  11. Wait one minute for the router to reboot.
  12. Manually enter the configuration information you wrote down in Step 4.

 

Document Type:

Downloads > Driver/Software/Firmware
Published 09/23/2010 04:39 AM   |   Updated 11/02/2011 03:57 AM

 

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.