JR6150 Firmware Version 1.0.0.18


New Features:

To Upgrade

Note: Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.

  1. Download and unzip the new file from NETGEAR Download Center by clicking the below URL. The filename after unzipping is JR6150_V1.0.0.18_1.0.1.img.

    Download Link: http://downloadcenter.netgear.com/en/product/JR6150

  2. Using a web browser, login to the router as admin
  3. Under Maintenance click Router Upgrade.
  4. Click Browse and locate the upgrade file JR6150_V1.0.0.18_1.0.1.img.
  5. Click Upload.
  6. Wait for the upgrade progress bar to complete and final prompt to appear.

    If problems occur after upgrading, try clearing the configuration by pressing the Factory Defaults pushbutton on the rear panel until the Test LED blinks (about 10 seconds). Then reenter your configuration information manually.

Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate.

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.