GS752TXS is NETGEAR's new generation of Gigabit Stackable Smart Switch with new or enhanced features. GS752TXS supports 48 10/100/1000 Mbps RJ45 ports and 4 10Gbps SFP+ ports within which two ports (port 51 and 52) can be used as stacking ports or as uplink ports.

GS752TXS supports the latest Smart Control Center, please use SCC version 1.1.2.1 or above for switch discovery, basic configuration and FW upgrades.

In this release, feature of production release was added and below customer issues were fixed.

Warning: This firmware image v5.2.0.26 cannot be used on GS728TXS. It may render the switch unoperational.

Fixed issues

1. The DUT will auto-reboot to apply the new txt configuration after downloading it successfully.
2. Error logs are continuously logged in memory every few seconds.
3. DHCP snooping binding items disappear after DUT reboots.
4. Fan LED is lit and 'Failure' is shown after firmware upgrading .
5. Fan speed controller initial in bootup stage is not correct

Known issues

1. No stack firmware synchronization logs on trap log when the stack firmware is in synchroning.
2. Cable test: the test result is incorrect when the counterpart port is disabled.
3. All learned MAC addresses are cleared when try to clear one specific MAC address

Limitations

1. Stacking SFP+ ports can only work with 10G mode, 1G mode is not supported.