Only for GS748Tv1h1 - Do NOT use this on v1h2 or v1h3 - for more details, check the GS748Tv1 firmware selection instructions.
Note: If you have firmware version 1.0.0, you must first upgrade to firmware version 1.1.0 before attempt upgrade to version 1.3.0.
After upgraded to version 1.3.0, you must reset the switch to factory default by using the Factory Default button on the switch or by clicking on Factory Reset on the Web GUI. Write down all the configuration you have changed. Use them to manually reconfigure the switch after upgrade.
Enhancements from v1.3.0-0606
1. Changes Jumbo Frames limit to 10240 bytes.
2. Modifies Jumbo Frame GUI.
3. Enables snmpOutTraps Counter.
4. Supports STP Trunk.
5. Adds Fast_Link_delay_timer 5 seconds.
6. Changes VTSS API version to 1.36
Enhancements from v1.3.0-0408
Download: Right-click and Save
Size: 217 KB
Published: July 6, 2005
D102721.asp
This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.