GS728TS, GS752TS, GS728TPS and GS752TPS Firmware Version 5.3.0.15

Supported Models:

GS728TS, GS752TS, GS728TPS and GS752TPS
• The GS728TS/GS752TS Smart Switch has 24/48 10/100/1000 Mbps copper ports and 6 SFP fiber ports, 2 of which are combo ports. Up to two SFP ports (the last two ports) at a time can be used as 2.5G stacking ports to create six unit stack system.
• The GS728TS/GS752TS Smart Switch has 24/48 10/100/1000 Mbps PoE capable copper ports and 6 SFP fiber ports, 2 of which are combo ports. Up to two SFP ports (the last two ports) at a time can be used as 2.5G stacking ports to create six unit stack system.

Known issues

1. Port is incorrectly up when insert 100BaseFX SFP module to port 25/26 (GS728TS/TPS) or port 49/50 (GS752TS/TPS).

   [Workaround] The 100Base-FX SFP module is not supported on port 25/26 of GS728TS and GS728TPS or port 49/50 of GS752TS and GS752TPS. Those ports only support 1Gbps SFPs or 10Gbps SFPs. The 100BaseFX optic can be used on the rest of SFP ports on these platforms.

2. The switch does not prompt error or warning message when try to configure the ports on the stack unit that does not exist.

   [Workaround] None.

Notes

This firmware release support dual firmware image. Before upgrade a stack system, please make sure that the 'Next-active' field under 'Maintenance->File Management->Dual Image status' pages are the same. They should be set to 'image1' as factory default.

Installation Procedure

GS7xxTS/TPS supports the latest Smart Control Center, please use SCC version 1.1.3.1 for switch discovery, basic configuration and FW upgrades.