Note

It will take about 8 minutes for the first boot up after upgrade to 6.0.1.18 from previous releases 6.0.x.x, because the switch will auto-upgrade the new PoE firmware. Please wait patiently till the switch completely boot up.
GS752TP, GS728TP and GS728TPP support Smart Control Center, please use SCC version 1.1.3.1 for switch discovery, basic configuration and FW upgrades.

New Features and Enhancements

• Improved switch security to guard against cross-site-scripting attacks.

Fixed issues

1. Only 4 source ports can be configured for port mirroring instead of 8.
2. LLDP-MED should be enabled by default.
3. Switch cannot provide PoE power to attached PD (Powered Device) if connected to another PSE (Power Sourcing Equipment).
4. Two typos in GUI page of VLAN membership.
5. Voice VLAN gets re-enabled after reboot.
6. GS752TP’s ports 9-48 works incorrectly in IEEE802.3at mode.
7. Switch reboots randomly when making calls using certain PoE IP phones  other after enabling auto-VoIP.

Known issues

• None.

Limitations

• Reboot is required when switching between ‘Switch’ mode and ‘Router’ mode.
• Dynamic Vlan assignment and DiffServ Simple policy (flow based policer) can only be supported in ‘Switch’ mode, but not supported in ‘Router’ mode.

Using the Download Link below, download and extract the new firmware to a convenient place such as your desktop.

Download Link: http://www.downloads.netgear.com/files/GDC/GS728TP/GS7xxTP_TPP_V6.0.1.18.zip