GS724TR/GS748TR Firmware Version 3.0.2

Modifications / Fixes:

1. Updated to new boot code - fixes the problem in some rare cases where device might not be able to boot up.

Known Issues:

1. When we delete the image from Web UI (Maintenance > File-Management > Dual image configuration) an error message pops up even though the image has been deleted successfully.
2. System allows different VLANs with the same VLAN name. 
   Workaround: Although this issue has no affect on the functionality of VLAN, it will be fixed in the next release.
3. Smartwizard Discovery tool fails to find the switch with high-rate of background broadcast and multicast traffic. 
   Workaround: Please follow the following steps (This issue will be fixed in the next release):
   1. Enable the ‘DiffServ Admin mode’ from QoS > DiffServ > Advanced > DiffServ config.
   2. Select the 'Class Configuration' link and create a new class (class1) with Protocol Type as UDP, Source L4 port as 64513 and Destination L4 port as 64515.
   3. Select the 'Policy Configuration' link and create a new policy (pol1) with member class as class1; and assign a Queue as 4 (you may select any other non-zero queue here).
   4. Select the 'Service Configuration' link and assign policy (pol1) on the interface that is connected to the PC with Smartwizard Discovery tool. A permanent fix will be provided in the next maintenance release.
4. Refreshing the page (Ctrl+F5) will always bring you back to the login page.

Note: Unlike most of other NETGEAR Switches, configuration change does not automatically get saved. Please go to Maintenance > Save Config > Save Configuration page to save the configuration if you want the settings to be preserved after reboot.

Upgrade Instructions:

1. Download the new firmware to a convenient place on your local system.
2. You would need to transfer the V3.0.2 FW to the switch via one of the following methods:
   1. Smartwizard Discovery tool
   2. TFTP in Maintenance > Download > TFTP File Download page
   3. HTTP in Maintenance > Download > HTTP File Download page
3. Go to Maintenance > File Management > Dual Image Status page; and note the image number that shows version V3.0.2.
4. Go to Maintenance > File Management > Dual Image configuration page and choose the active image (image1 or image2) corresponding to V3.02 to be updated.
5. Check the ‘Active Image’ and ‘Update Bootcode’ option.
6. Click Apply.
7. You need to reboot the switch.
8. The boot code will be updated.

Document Type:

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.