New Features:

• None.

Issue(s) are resolved since last Release V3.0.9-01:

• Need options to set TCP and UDP Flood limits.
• Respond to ping on WAN interface for ANY IP and a single IP Address.
• Idle timeout field is NOT needed for IPSec users.
• VPN tunnel is not working on loadbalance mode.
• Cannot add a ipsec user with space.
• Fail to add ipsec local user which name with space.
• After adding Secondary LAN IP, IP Address and Subnet mask aren't blank.
• Select all day, schedule 1,2,3 are not same about that specific day still be selected.
• List below ports in GUI help Security - Service page.
• After changing gateway vpn to client vpn, the tunnel cannot be up.
• IPsec policy lose when remote id is 0.0.0.0 after DUT reboot.
• No ipsec tunnel uptime in online help document.
• Increase this month limit can't disable.
• Support link is not expect web.
• The reboot time unmatch between popup message and the reboot page.
• Identifier canot input 131 characters.
• Bandwidth profile displaying abnormally when edit outbound bandwidth profiles to inbound.
• VPN wizard online help does not match the function.
• Dynamic DNS status display with messy code.
• No ipsec tunnel uptime in online help document.
• Redundance message in ipsec mode config record .
• Cannot Creating firewall rules for TCP Port 113 (ident).
• VPN wizard gui values is not matching with the VPN Wizard default values in online help document.
• Unable to access attack checks page, observed "ADPOK" message.
• NFS service does not work in firewall rules.
• Device freeze once or twice a week.

Known Issue(s) and Limitations:

• Inbound voices are not heard between sip clients over vpn tunnel when sip server is lying in the remote private network.
• SIP clients at other end of tunnel are unable to register through VPN tunnel when SIP server is in LAN side of  DUT.
• SSL VPN logs page not showing logs when ssl and port forwarding users  disconnected.
• Unable to do ftp data tranfer when ssl client is behind nat router in port forwarding tunnel.
• Unable to edit the ipsec vpn user while in use.
• Bandwidth profile is not working over vpn tunnel.
• Protocol binding should be configurable only in load balancing mode, but can be configured in dedicated & auto roll over modes also.
• When a Firewall rule for Address Range is edited and Block always is selected the "WAN Destination IP address" is greyed out.
• IGMP information need to be updated in attack check help page.
• PPTP idle time out is not working when IGMP proxy enabled.
• Inconsistant behavior while establishing calls between LAN and WAN and vice-versa with IGMP Pass through enabled. 

Installation Instructions:

• Download the link below and save it to a convenient place such as your desktop.
  Note: Reboot the firewall before begining the update process.
  
• Select Administration > Settings Backup and Firmware Upgrade from the main/submenu.
• In the Router Upgrade section, click Browse.
• Locate the downloaded file and click Upload.
  This will start the software upgrade to your VPN firewall.  This may take some time. Do not interrupt the upgrade process.
  At the conclusion of the upgrade, your firewall will reboot.