New features:

1. IPv6 Firewall support.
2. IPv6 Prefix Delegation.
3. IPv6 IPSEC and SSL VPN.
4. Multiple SSID for wireless.
5. CLI support.

Bug Fixes:

1. Loopback does not work for DMZ LAN.
2. When you click the Auto detect button on the WAN Settings page, you cannot connect to the internet for more than 7 minutes.
3. Cannot establish a tunnel using Radius-PAP authentication.
4. Ping using Diagnostic tool in GUI fails over anipv6 IPSec tunnel.
5. Sometimes synchronization takes too long.
6. Cannot configure FQDN in the 'Add New VPN Policy' page.
7. The DMZ WAN cannot connect after adding a route.
8. You cannot configure an IPSec "client to gateway" vpn that uses an IPv6 address in the VPN Wizard page.
9. You cannot add the customer vlan when its DHCP server is disabled and you cannot disable the DHCP server of the default vlan.
10. Unit shows a critical error when packets are captured.
11. Cannot configure a LAN DHCP relay.
12. Forwarding performance is improved.
13. GUI response is Improved. 

To Upgrade

IT IS VERY IMPORTANT TO NOT POWER-CYCLE THE UNIT BEFORE THE UPGRADE COMPLETES! IF YOU DO INTERRUPT THE UPGRADE, THE ROUTER WILL BE RENDERED USELESS!

1. Select the download appropriate to your region, and download to a convenient place such as your desktop.
2. Using a browser, login to the router as admin.
3. Under Management, click Router Upgrade.
4. Click Browse and locate the upgrade file you just downloaded
5. Click Upload. The upgrade process may take up to ten minutes or more; in rare cases it might take even longer.
   
6. Please wait for the yellow TEST LED to turn off before connecting to the GUI again.
7. Once the upgrade is complete, the browser may show an error page (404 – Page not found). At this point, please connect to http://192.168.0.1 to access the new GUI.

   For problems after upgrading, clear the configuration, using the Factory Defaults pushbutton on the rear panel, or the Erase button in the Backup Settings menu. Then reenter your configuration information manually.

d103294.asp