Bug Fixes:

Fixed the following issues that was found on Win10 edge with build 10130.

• Fixed the issue where no message pops up when selecting the option "no, I want to configure the Internet connection myself" and clicking on "Next" button, in Genie wizard.
• Fixed the issue where the Wireless setting and Guest management page setting cannot be applied, and channel shows abnormal.
• Fixed the issue where the FTP port and HTTP port cannot be set, in USB advanced setting page. 
• Fixed the issue where the "Add keyword" button does not work, in block sites page.
• Fixed the issue in which the invalid value(for example: set email address to 'r') of email server address can be set, in Email page.
• Fixed the issue where the newly added rule and edit rule shows abnormal, in static router page.
• Fixed the issue where the apply button does not work, in remote management page.
• Fixed the issue where the bandwidth value can be set to invalid value(not digital value,such as 'w'), in QoS setup page. 
• Fixed the issue where no warning message pops up while entering invalid IP value,for example,change ip to '192.168.1.e', in LAN setup page.
• Fixed the issue where no warning message pops up when no values are entered in add an Auto policy or manual policy,and clicking on Apply, in VPN policies page.

To Upgrade

Note: To avoid wireless disconnect issue during the firmware download process, NETGEAR recommends that firmware upgrade be performed on a computer with wired connection.

1. Write down all the settings which you changed from the default values, since you may need to re-enter them manually.
2. Using the Download Link below, download and extract the new firmware to a convenient place such as your desktop. The filename after extracting is DGND3700v2-V1.1.00.26_1.00.26.img
   
   
   Download Link: http://www.downloads.netgear.com/files/GDC/DGND3700V2/DGND3700v2-V1.1.00.26_1.00.26.zip
   
   
3. Using a web browser, login to the router as admin.
4. Under Maintenance click Router Upgrade.
5. Click Browse and locate the upgrade file.
6. Click Upload.
7. Wait for the upgrade progress bar to complete and final prompt to appear.

If problems occur after upgrading, try clearing the configuration by pressing the Factory Defaults pushbutton on the rear panel until the Test LED blinks (about 10 seconds). Then reenter your configuration information manually.

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.