DG834Nv1 Firmware Version 1.02.15

WN121T Users:

To maintain interoperability between WN121T and DG834N in 802.11n mode, you must upgrade the firmware on DG834N to version 1.01.06 or above and also upgrade your WN121T software to version 2.0 or above. Visit WN121T Product Page

New Features & Bug Fixes

1. The manual has been updated and is accessible by clicking on the Web Support Documentation link when the Router is on-line.
2. Added support for configuring up to four SSIDs (SSID is the Wireless Network Name). To configure multiple SSIDs go the Wireless Settings page. The Region, Channel, and Mode set with the first SSID apply to all SSIDs.
3. Added support for Automatic Daylight Savings time. To enable Auto DST check Enable Automatic Daylight Savings Time Adjustment on the Schedule page.
4. Added a feature to allow the Access Point (AP) to be enabled and disabled by Schedule. This feature can be configured on the Wireless Settings page.
5. Added a feature to allow Remote Management from a list of up to ten discrete IP addresses (but just one at a time). This feature can be configured on the Remote Management page under Advanced, click on IP Address List.
6. Fixed a problem where email that had been received from the router had a date exactly one month in the future.
7. Fixed a problem where the wireless N speed was always displayed as "Up to 130Mbps" when the channel was set to "Auto". 

To Upgrade

1. If you've changed any values from the defaults, write them down. Then if you ever need to do a factory reset, if there are problems upgrading, you'll have all the information necessary to reconfigure the device.
2. Download using the button below, saving to a convenient place such as your desktop. 
   
3. Using a Web browser, login to the router as admin
4. Under Maintenance click Router Upgrade
5. Click Browse and find the upgrade file that you just downloaded. 
6. Click Upload
7. Wait for the upgrade progress bar to complete and final prompt to appear.

For problems after upgrading, try clearing the configuration by pressing the Factory Defaults pushbutton on the rear panel until the Test LED blinks (about 10 seconds). Then reenter your configuration information manually.

Document Type:

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.